GEN ENERGY 290Wh / 20Ah Li-Ion V-Mount Battery (15A Max. Discharge Rate)

Description

GEN ENERGY 290Wh / 20Ah Li-Ion V-Mount Battery (15A Max. Discharge Rate)

• Biggest power min. 180W can be supplied. ( 15A x 12V = 180W) It is the max. power through current standard v mount pin on the market.
• Min. 180W will give you relief on your mind when you use various equipment during shooting.
• D-tap has the biggest power also, 12A ??144W. These days multi D-tap is getting more and more popular, so this 144W D-tap will be enough.
• Shock-proof, Short-proof, Lowest impedance.

CHARGE

• Do not use the battery (Main, D-Tap, USB) while charging. If so, it may cause a charging error or damage the charger.
• Charge the battery to full before first use.
• When you charge this battery, Battery capacity LED gauge button will turn on indicating the capacity being charged.
• Lithium ion batteries have a slight self discharge, therefore it is recommended to charge prior to use.??

DISCHARGE

• Do not use the battery (Main, D-Tap, USB) while charging. If so, it may cause a charging error or damage the charger.
• Camera’s low voltage alarm is recommended to set 13~13.5V
• Battery will stop at 12V to extend its life.* Microwave transmitters with 5W outputs or over should be kept as far away from the battery. It may disrupt or stop supplying power.
• Be sure to remove the battery from the device after use. If so, it will consume large standby power and over-discharge protection may be activated.
• USB is activated by pushing Battery capacity LED gauge button. USB power will turn on automatically 30 minute after no use.
• Battery run time reduces when it is working below or above the recommended temperature range.

Tech Specs
Type: V-Mount Battery
Cell chemistry: Li-ion
Norminal voltage: DC 14.4V
Capacity: 20Ah
Charge voltage: 16.8V
Charge current: Max. 6A
Max. discharge rate: 15A
D-Tap Output norminal voltage: 14.4V
Max. load:12A
USB Output voltage: DC 5.0V
Max. load: 2.3A
Auto power off: 30 minutes after no use
End voltage: 12V
Battery protection circuit: Over-charge, Over-discharge, Over-current ( Cell and Pack separately), Over-temperature, Reverse charge
Ambient temperature To charge: 10??C ~ 30??C (32??F ~ 104??F recommended)??
To discharge: -20??C ~ 50??C ( -4??F ~ 122??F), 10??C ~ 40??C (50??F ~104??F recommended)
To store: `-20??C ~ 40??C ??(-4??F ~ 104??F) (<85% RH) (less than 1 month)??
Dimension: 97(W) x 146(H) x 78(D)mm 3.82(W) x 5.75(H) x3.07(D)”
Weight: approx. 1520g / 3.35lb